← Back to Knowledge Base

    ★ .22LR Knowledge Base

    Preparing a .22LR Rifle for Long Range

    By Joe Eldridge

    © Property of Texas Long Gong

    You are welcome to share a link to this article or link back to it from your own site. Please do not copy, republish, or rehost the article in whole or in part on another site. Backlinks are encouraged; lift-and-shift is not permitted.

    Long-range .22LR shooting — ringing steel (the "long gong") out to 300 yards and beyond with a cartridge originally designed for plinking at 50 — is a discipline that punishes every weakness in your setup. The bullets are slow, the time of flight is long, and a 40-grain pill gives the wind plenty of time to play with it on the way to the target. Getting consistent hits requires deliberate choices in optics, support gear, trigger, and ammunition. Here's how to set up a rifle that's actually capable of holding a vertical waterline at distance.

    Scope Mount: Start with a Canted Rail

    Pick up a scope rail with at least 30 MOA of built-in elevation. From a 50-yard zero you'll typically need to dial somewhere between 11 and 13 mils (roughly 38–43 MOA, YMMV) up to reach 300 yards depending on your ammo's velocity. A 30 MOA rail gets you there and beyond most of the time, and it keeps your turret operating closer to the middle of its travel where tracking is most reliable.

    A flat (0 MOA) rail will leave you running out of "up" before you ever see the long gong.

    Optics: Magnification Matters More Than Reticle Type

    MOA or mil is purely personal preference — pick whichever your brain prefers and commit to it. What does matter is magnification. You need at least 24x to spot your misses on the berm at 300 yards. .22LR splash is small and fast, and remember — your spotter is only calling hits and misses. They aren't telling you where the miss landed. If you can't see your own splash through the scope, you have nothing to correct off of for the next shot.

    Bipod and Rear Bag: Stable, Locked Up, Not Loaded

    A good long-range rimfire bipod needs to be stable and lock up tight. The goal is a platform that doesn't move under recoil and that you don't have to "load" (preload forward pressure into) to settle.

    Imparting any energy on the rifle outside of your trigger pull is your enemy. Be light on the rifle — but at the same time, control the movement. This is especially true with the rear bag. Remember:

    A .22LR bullet spends more time in the barrel than any other common cartridge.

    That gives you plenty of time to screw up the shot. Whatever the rifle is doing during ignition gets translated to the target. Subtle muzzle rise, a twitch in the rear bag, or a sloppy bipod that walks under recoil will all show up downrange — magnified by the long flight time.

    Trigger: Lighter Than You Think

    Triggers are personal preference, but the reality of what's working at the top of the leaderboard is consistent:

    Top precision rimfire shooters are running triggers under 1 lb.

    Many are down to 2 oz or even lighter.

    You're trying to break the shot without disturbing the rifle. The lighter and cleaner the trigger, the easier that is. Build the discipline alongside the gear — a 2-ounce trigger in untrained hands is a safety problem, not an advantage.

    The Real Enemy: Vertical Dispersion

    Wind gets the blame for most missed long-range .22LR shots, but the silent killer is vertical dispersion. Velocity inconsistency walks your impacts up and down the target, and it does so even with very small velocity spreads.

    Run the numbers on a typical match round (Lapua Center-X or similar, G1 BC ~0.14, standard conditions):

    Muzzle Velocity — Drop at 300 yd
    1100 FPS ~129 in
    1090 FPS ~131.6 in

    That's roughly 2.4 inches of vertical dispersion in a vacuum / simple-drop calculation, and closer to 3.5 inches once you account for air drag — from just a 10 FPS spread.

    A 10 FPS extreme spread is small. And it's still enough to push your impact out of a standard 10-ring or off a small steel target.

    Track Your Extreme Spread

    If you're not chronographing match ammo and tracking lot performance, start now. The two numbers that matter:

    • Extreme Spread (ES) — your worst-case round-to-round delta
    • Standard Deviation (SD) — how tightly the velocities cluster around the average

    If you can get SD around 5 or better, you're in pretty good shape for holding the vertical waterline at distance. Barrel tuners can help calm down the extremes by reducing the impact of the few flyers in a lot, but a tuner can't fix bad ammo — it can only optimize good ammo.

    Ammo Counts — and 50-Yard Bughole Ammo Doesn't Always Translate

    This is the trap a lot of shooters fall into: that perfect bughole lot at 50 yards doesn't necessarily hold up at 300. We see it all the time. A lot can shoot one ragged hole at the close target and still throw vertical fliers at distance because its velocity SD is mediocre — 50 yards is simply too short for velocity variance to walk the impact off the bull.

    When testing ammo for long range, the relevant test is at long range. At minimum, chronograph extensively and prioritize lots with low SD. Tight groups at 50 are necessary, but not sufficient.

    Quick Reference

    • Rail: 30 MOA minimum
    • Scope: 24x minimum; mil or MOA, either works
    • Bipod: stable, locks tight, no preload required
    • Rear bag: controlled, light pressure, no energy in the rifle outside the trigger press
    • Trigger: sub-1 lb (top shooters are often 2 oz or less)
    • Ammo: SD ≤ 5 where possible; chronograph and track ES; test at distance
    • Tuner: consider one to tame extremes — but only on already-good ammo
    • Mindset: be light on the rifle, the bullet is in the barrel a long time, don't disturb it

    Get these elements right and you've removed most of the equipment-side excuses for missing the long gong. What's left is the part that's always been hardest in shooting: doing the same thing the same way, every shot.

    The Best Thing You Can Do: Go Shoot a Match

    Reading articles and tuning gear at the bench will only take you so far. The single fastest way to get better at long-range rimfire is to show up to a match. You'll learn more in one match day — about wind reads, bench shooting, ammo performance at distance, and your own rifle — than in a month of solo range time.

    And of all the precision rifle match styles out there, Long Gong is the least intimidating one I know of. The pace is relaxed, the round count is manageable, the rifles are rimfire so recoil and noise aren't a factor, and the community is genuinely welcoming to new shooters. Targets are steel, so feedback is immediate and obvious. Nobody expects you to clean the course your first time out — they expect you to ask questions, borrow a wind call, and have a good time figuring it out.

    Don't let the shiny hardware intimidate you either. Walk down the firing line at most Long Gong matches and you'll see plenty of stock CZ 457s and Bergara B14R's — and they often win, even in factory form. We've seen Ruger RPRs take the top spot. Long Gong doesn't demand the rails-and-bags-and-dope-card arms race of PRS or NRL. Shooting skill and a little luck with the wind matter far more than the price tag of the rifle. Yes, the shiny hardware will be on the line. Don't let it deflate your participation.

    If you've been waiting for the "right time" to try a match, this is the format to start with. Find a local Long Gong match, sign up, and bring the rifle you have. The gear list above is what you'll work toward — not what you need on day one.

    Share this article

    Community rating

    Be the first to rate

    Comments on Preparing a .22LR Rifle for Long Range

    Loading…