← Back to Knowledge Base

    ★ .22LR Knowledge Base

    Reading the Wind to the MPH
    for .22LR Precision Rimfire

    By Joe Eldridge · November 15, 2026

    Why the Wind Owns a .22LR

    With a .22LR, wind is the whole game. A 40-grain round-nose bullet leaving at about 1,070 fps loses speed fast and stays in the air a long time. At 300 yards a standard-velocity round is in flight for more than a full second, and every bit of that second the wind is pushing on it.

    A centerfire shooter can misread the wind by 2 mph at 300 yards and still hit. A rimfire shooter who misreads by 2 mph at 300 yards misses by almost 8 inches. So you can’t stop at “there’s a light breeze from the left.” You need to call it to the mph, and you need to do it fast, using what’s in front of you: grass, trees, flags and wind flags.

    This article puts real numbers on how much the wind moves a .22LR at 50, 100, 200 and 300 yards. It then shows how to turn what you see downrange into an mph number you can dial or hold.

    How Far 10 mph Moves a .22LR: 50 to 300 Yards

    A 10 mph full-value crosswind moves a standard-velocity .22LR about 1.25 inches at 50 yards, 4.7 inches at 100, 17.8 inches at 200 and 38.6 inches at 300. Going from 100 to 300 yards triples the distance but multiplies the drift by about eight.

    Distance (yd)Time of flight (s)Drift, 10 mph (in)Drift (MOA)Drift (mil)Drift per 1 mph (in)A 2 mph misread costs (in)
    500.151.252.40.70.130.25
    1000.314.74.51.30.470.95
    2000.6517.88.52.51.83.6
    3001.0438.612.33.63.97.7

    These numbers are from a point-mass G1 ballistic solver for a 40 gr standard-velocity load at 1,070 fps (G1 BC 0.13), zeroed at 50 yards, at standard atmosphere. Your ammo and conditions will be a little different, so treat these as a starting point and check them against your own shooting.

    The right column is the one that matters. At 50 yards a 2 mph misread is lost in the group. At 200 yards it’s 3.6 inches, which is enough to miss a small plate. At 300 yards it’s nearly 8 inches. The farther you shoot, the finer your wind call has to be.

    Why High-Velocity Ammo Drifts More, Not Less

    You might expect a faster bullet to drift less. With .22LR it doesn’t work that way. A 40 gr high-velocity load at 1,250 fps drifts about 6.3 inches at 100 yards and 47.6 inches at 300 in the same 10 mph wind, roughly 25 to 35% more than standard velocity.

    The reason is the sound barrier. High-velocity rounds leave the muzzle supersonic and slow through the transonic zone, roughly 1,100 to 1,000 fps, inside the first 50 to 100 yards. Drag rises sharply in that zone. Wind drift depends on how much flight time the bullet loses compared to flying in a vacuum, not on raw speed. Standard-velocity ammo starts subsonic and stays there, which is why match shooters use it.

    Wind Value: Speed Is Only Half the Call

    An mph number is useless until you know how much of it is crosswind. Picture yourself in the middle of a clock face with the target at 12 o’clock, then name the hour the wind is blowing from.

    Wind from (o’clock)ValueMultiply mph by
    3 or 9Full1.0
    2, 4, 8 or 10Nearly full0.85 to 0.9
    1, 5, 7 or 11Half0.5
    12 or 6No value0

    So a 10 mph wind from 1 o’clock pushes like a 5 mph full-value wind. At 200 yards that’s about 9 inches, not 18.

    Be careful with winds near 12 and 6. A small change in direction swings the value fast: a 10 mph headwind that shifts from 12 to 1 o’clock goes from no drift to 5 mph of full value. Watch the direction as closely as the speed.

    Reading Vegetation to the mph

    Grass, weeds, leaves and branches each start to move at a fairly consistent wind speed. Learn those thresholds and the whole range becomes a wind gauge. The scale below is adapted from the Beaufort scale for the speeds that matter to rimfire.

    Wind (mph)Grass and weedsLeaves and treesYou feel
    0 to 1Still. Seed heads don’t move.Leaves still. Smoke and dust rise straight.Nothing
    1 to 3Tallest weed heads and grass tips stir now and then.A few leaves flutter, mostly at the top.Barely, on a wet cheek
    3 to 5Grass tops lean and sway gently.Leaves rustle steadily. Light twigs start to move.On your face and ears
    5 to 8Tall grass sways steadily and stays leaned over.Leaves and small twigs keep moving. Light-colored leaf undersides show.Steady on your face
    8 to 12Waves roll across the field.Small branches move. Dust and loose paper lift.Pushes on your hat brim and clothes
    12 to 18The whole field moves in big waves and flattens in gusts.Small trees sway. Ponds get small whitecaps.Strong enough to move the rifle
    18+Grass stays flat.Large branches move and you can hear it.Not a good day for 300 yards

    Tips for Reading Vegetation

    • Use the tall stuff. Tall grass, cattails and weed heads react at 2 to 3 mph. Short mowed grass barely shows anything under 8 mph.
    • Watch the waves, not single blades. Waves moving across a field show the speed and direction of the gusts. If they’re coming toward your line of fire, you have a few seconds to wait or adjust.
    • Watch the leaf undersides. Cottonwood, poplar and silver maple show their pale undersides at about 5 to 8 mph. A tree turning silver means the wind just picked up.
    • Treetops aren’t your bullet’s path. Wind 30 feet up is often faster than wind at bullet height. Use the treetops for direction and an early warning. Use the grass and weeds near the bullet path for speed.
    • Read the middle and the target, not just your shooting position. At 200 and 300 yards the wind at midrange can be different from the wind at your bench. With a .22 in the air for a full second, the wind along the whole path counts.

    Reading Flags: The Angle Method

    For a standard cloth flag on a pole, a good field estimate is: the angle between the pole and the flag in degrees, divided by 4, gives the wind speed in mph. This rule is taught in military marksmanship, and it holds up well for an average-weight cotton or poly flag.

    What the flag is doingAngle from poleWind (mph)
    Hanging limp0°0 to 3
    Lifting and dropping, edge flutteringabout 20°about 5
    Halfway outabout 45°10 to 12
    Mostly out, still falling backabout 65°about 15
    Straight out and snapping80 to 90°20 and up

    Things That Throw the Angle Off

    • Flag weight. Light nylon flags rise sooner than heavy cotton. A wet flag reads several mph slow.
    • Flag size. A big flag needs more wind to lift. A small pennant reacts sooner.
    • Height. A flag on a 20-foot pole is reading wind above your bullet’s path, which is usually faster. Use it for direction and gust timing more than exact speed.
    • The bottom of the range. Below about 5 mph a pole flag just hangs there, and that’s the speed range where a .22 at 200 yards still moves 3 to 9 inches. You need something more sensitive down low, which is why rimfire shooters use wind flags.

    Reading Wind Flags: The Low-Wind Gauges

    Wind flags are the most precise way to read 0 to 10 mph, the range where most rimfire matches are won or lost. They come in three common types, and each one tells you something different.

    Wind flag typeBest range (mph)What it tells you
    Ribbon or surveyor tape on a stake0 to 8Direction instantly. Speed by how high the tape rides.
    Benchrest-style flag (vane, tail and propeller)0 to 15Direction from the vane. Speed from tail angle and propeller spin.
    Spinner or daisy wheel only1 to 10Changes and lulls. Faster spin means more wind.

    Ribbons and Surveyor Tape

    A 2- to 3-foot strip of surveyor tape on a stake at bullet height is cheap, and it reacts to as little as 1 mph. As a starting point: tape hanging straight down or just twitching means 0 to 2 mph. Tape at about 45° means about 4 to 6 mph. Tape riding flat and fluttering means 8 mph or more, and above that it stops telling you much. Put several down the range, at least one near the bench, one at midrange and one near the target.

    Benchrest-Style Wind Flags

    These have a vane that points into the wind, a light tail that lifts as the wind builds, and a propeller or spinner on the front.

    • Direction: read the vane. Then use the clock to set the value.
    • Speed: read the tail angle. A drooping tail means 0 to 3 mph. A tail at about 45° means roughly 5 to 7 mph. A tail flat out means 10 mph or more. Every flag is different, so calibrate yours (below).
    • Changes: watch the propeller. You’ll see it speed up or slow down before the tail moves. When it speeds up, a gust is coming. When it slows, a lull is coming.

    Calibrate Your Own Flags

    The numbers above are approximate. Exact mph depends on the material, length and weight of each flag. Spend one practice session calibrating:

    1. Hold a handheld anemometer, such as a Kestrel, next to the flag at the same height.
    2. Write down the tail or tape angle, and how fast the propeller spins, at 2, 4, 6, 8 and 10 mph.
    3. Tape that card to your flag box or rifle stock.

    After that, every flag on the range is a gauge you trust to the mph. The anemometer only measures the wind where you’re standing. The flags measure it all the way downrange.

    How to Read a Line of Flags

    • Weight the flags by what your bullet is going through. At 50 and 100 yards, the flag between you and the target is usually enough. At 200 and 300 yards, read every flag and average them. Give a little extra weight to the first half of the path, since a push early in flight has more distance to grow.
    • When flags disagree, the wind is switching. Flags pointing different ways mean a direction change is moving down the range. Wait for them to line up, or shoot only when they match the condition you’ve dialed.
    • Shoot a condition, not a guess. Pick the condition you see most often, dial it, and fire only when every flag shows it. That beats chasing every change.

    Putting It Together at the Line

    A good wind call follows the same four steps every time: direction, speed, value, correction.

    1. Direction. Read the wind flag vanes, or the way the grass waves are moving. Name it as a clock hour.
    2. Speed. Read the most sensitive gauge at bullet height. Use tape or wind flag tails under 8 mph, grass and leaves from 3 to 12, and pole flags above 10. Cross-check two sources when you can.
    3. Value. Multiply the speed by the clock value: 1.0, about 0.87 or 0.5.
    4. Correction. Multiply the full-value mph by your drift per mph for that distance (quick reference card below). Dial it, or hold it in the reticle.

    Then watch for change while you break the shot. If the flags or grass change before the trigger breaks, stop and call it again.

    Worked Example at 200 Yards

    The wind flag tails are riding at about 45°, which you’ve calibrated as 6 mph. The vanes point to 2 o’clock, a value of about 0.87, so you have about 5 mph of full value. At 200 yards a standard-velocity .22 drifts about 0.25 mil per mph. Hold 1.25 mil into the wind, which is about 9 inches.

    Now a gust lifts the tails to flat out, about 10 mph. That’s about 9 mph of full value and 2.2 mil. If you didn’t see the gust and fired with the 1.25 mil hold, you’d miss by about 7 inches.

    Habits That Win Rimfire Matches

    • Shoot in the lulls. At 300 yards a .22 spends a full second in flight. A steady 5 mph is easier to hit in than a 3 mph wind gusting to 8.
    • Use sighters to confirm your reads. Your first shots on a stage tell you whether your mph reads match your ammo and flags. Adjust your mental chart, not just your hold.
    • Keep a wind log. After each match, write down the flag readings, your call and where the bullet went. Your eye improves fastest when you compare what you saw against what the bullet did.

    Quick Reference Card

    Corrections per 1 mph of full-value wind for 40 gr standard-velocity .22LR at 1,070 fps. Scale from here, then fine-tune with your own sighters.

    Distance (yd)Per 1 mph (in)Per 1 mph (MOA)Per 1 mph (mil)Wind for 1 mil (mph)
    500.130.240.0714
    1000.470.450.137.5
    2001.80.850.254
    3003.91.230.362.75

    To remember: 1 mil of wind at 100 yards takes about 7.5 mph. At 200 it takes about 4 mph, and at 300 under 3 mph.

    Speed Cues at a Glance

    • 0 to 3 mph: tape twitching, weed heads stir, pole flag limp
    • 3 to 5 mph: felt on your face, leaves rustle, tape at about 45°
    • 5 to 8 mph: tall grass leans steadily, leaf undersides show, wind flag tails at about 45° or higher
    • 8 to 12 mph: waves roll across the field, small branches move, pole flag halfway out
    • 12 mph and up: small trees sway, pole flag mostly out, every shot past 200 yards is a hard call

    Article by Joe Eldridge for the Texas Long Gong .22LR Knowledge Base.

    Share this article

    Community rating

    Be the first to rate

    Comments on Reading the Wind to the MPH

    Loading…